Determine whether the charging base is faulty:
Place the sweeper 1.5 meters away from the charging base, manually start the sweeper \"automatic recharge\" function, check whether it can successfully return to the base, if not, directly move the sweeper to the base, manually align the charging pole, see whether it can be charged normally, if it can be charged, it means that the base of the signal is faulty, should be repaired.
Check the environmental factors that affect recharge:
The sweeping machine can not find the base, the first thing to do is to check the environment where the charging base is placed, in general, the charging base should be placed on an open and flat ground, close to the wall, away from the place with steps or a drop, and there is no debris in the front and on both sides within 0.5-1 meters.
The reason is that the power of the sweeping robot is too low to automatically shut down, you can charge it first, and the power can be turned on and used.
Troubleshooting method:
< br >
1. Push the power switch 2-3 times (lift the cover, above the dust box) at intervals of a few seconds, and finally push it to the \"N\" place to start.
< br >
2. Observe the start button light display after starting:
< br >
① In power state: press the start button for 3 seconds and then repeat this action to check whether the key is stuck.
< br >
② Low power or no power state: Dibao and the charging base docking long charge 4-5 hours before use observation.
< br >
③ Fault light display: according to the fault prompt voice removal.