Hello, stamping workers should follow the following specifications, I hope to help you:
1. When the mechanical press is used for blanking and forming, this regulation shall be observed; When forging or trimming, the relevant rules of forging should also be observed.
2. Exposed transmission components must be protected. Do not drive or test with the shield off.
3. Before driving, check whether the main fastening bolts of the equipment and mold are loose, whether the mold is cracked, and whether the control mechanism, emergency stop mechanism or automatic stop device, clutch and brake are normal. If necessary, the big press can start the point switch test, the small press can be used to pull the test, the test process should pay attention to finger safety.
4. Mold installation and debugging should be carried out by trained mold workers, and measures such as cushion plate should be taken during installation and debugging to prevent upper mold parts from falling and injuring hands. Stamping workers shall not install and debug molds without authorization. The installation of the mold should make the closing height correct, try to avoid eccentric load, the mold must be tight and firm, pass the test, can be put into use.
5. Stay focused at work. Do not talk or smoke while operating. Do not put your hands or other parts of your body into the danger zone when feeding or receiving materials. Auxiliary tools (special tweezers, hooks, suckers or feeding mechanisms) should be selected for processing small parts. When the mold is stuck in the blank, only tools are allowed to free and remove it.
6. When more than two people operate, people should drive, unified command, and pay attention to coordination and cooperation.
Seven. If the stamping machine is running abnormally or there is abnormal sound, such as knocking and cracking, it should be stopped to find out the cause, loose transmission parts or fasteners, continuous impact caused by the failure of the control device, and the mold crack should be stopped immediately for repair.
8. When troubleshooting or repairing, the power and air supply must be cut off, and the machine can be carried out after the machine completely stops moving.
9. After each workpiece is flushed, the hand or foot must be removed from the button or pedal to prevent misoperation. It is strictly prohibited to press the button or the foot pedal to make the circuit open and perform connected operation. Connected car operation shall be approved or in accordance with process documents.
10. Stand or sit firmly during operation. Others contact work should stop first, then receive. No unrelated personnel are allowed near the puncher or operator.
11. When cooperating with the driving operation, the safety operation regulations of the hook workers should be observed.
12. In the production of billets and workpieces to be stable, neat, not too high, stamping bed workbench is prohibited to stack billets or other objects, waste should be cleaned in time.
13. After the work is completed, the mold should be put to rest, cut off the power and air source, and carefully clean up the tools used and clean up the site.