The charging and control methods of the drone are as follows:
Charging: Plug the drone's battery into the charger, plug the charger into the power supply, and wait for the charging to complete.
Bind the remote control: Turn on the power of the remote control and press the pairing key on the remote control at the same time. The drone will make a drop sound, indicating that the binding is successful.
Start the drone: Put the drone on a smooth ground, press the take-off button on the remote control, and the drone will automatically take off.
Control the drone: Use the joystick on the remote control to control the direction, altitude and speed of the drone for filming or flight operations.
Take photos or videos: Use the photo or video button on your remote control to take photos or record videos during the flight.
Landing drone: At the end of the flight, press the landing button on the remote control, and the unmanned vehicle will automatically land on the ground.
Turn off the drone: Turn off the power of the drone, remove the battery, and store it in a dry, ventilated place.
considerations
During the flight, avoid flying the drone into no-fly or dangerous areas.
Before the flight, it is necessary to confirm that the UAV has sufficient power to avoid accidents caused by insufficient power.
During the flight, keep the signal between the remote control and the drone unblocked to avoid signal interference.
After the flight, clean the drone and remote control promptly and store them in a safe, dry place.
To charge and operate the drone, you first need to connect the drone to the remote control. Plug the battery into the drone using the charger that came with the drone and connect the charger to a power source for charging. Wait for the charger indicator light to turn green to indicate that charging is complete.
Then, you turn on the remote control and pair it with the drone, usually by pressing a specific button. After the pairing is successful, the rocker and button on the remote control are used to control the flight of the drone, take photos and video. To be safe, be sure to read the manual of the drone and remote control carefully and follow the instructions for charging and operating the drone.
Step\/Method 1
First, hold down the drone battery clip and pull out the battery from the bottom of the fuselage.
Step\/Method 2
Connect one end of the charging cable to the battery and the other end of the USB plug to the charging device for charging.
Step\/Method 3
The LED indicator on the battery is red when charging, and the indicator is off when it is full.
Step\/Method 4
Reattach the drone body after charging.
There is only one way to charge the drone, that is, directly connect the data cable with the original charger, but some drones are not very restrictive, you can also take the micro-usb data cable charging. However, most of the UAV requirements are still very strict, and the requirements for charging are also very strict.
< br >
,
< br >
Note on UAV charging:
< br >
1, if the user receives a new drone battery, it needs to charge the battery to 100%.
< br >
2, if there is no way to fill, the best short-term storage level of the battery is about 70%, in the first 2 days before the user uses the battery to run, the user needs to charge it to 100%.
< br >
3. After using the drone, the user needs to charge the battery to 70% again for the next use.
< br >
4, if the user finds that the available flight time of the drone has decreased significantly after charging the battery, it is not necessary to continue to use the battery or charge the battery, most of the batteries at this time have internal faults.