< p >
Internet Settings
1. Log in to the router management page
Open the browser, clear the address bar and enter the management address tplogin.cn at the bottom of the router (some types of routers may not be able to login through the domain name, please refer to the login address on the bottom label of the router shall prevail), in the pop-up setting management password interface, set a 6-15 digit management password, click Yes, log in to the router management page.
Note: Remember the set management password for subsequent management of the router.
< p >
2. Select the number of WAN ports
Follow the quick configuration wizard to set the number of WAN ports, that is, the number of extranet lines.
< p >
3. Select the WAN port Internet access mode
Select the Internet access mode of PPPoE, static IP, or dynamic IP based on the broadband type. This section uses broadband dial-up Internet access as an example. Select PPPoE dial-up in the corresponding Settings box, enter the broadband account and password provided by the carrier, and ensure that the password is correct. Click. The next step.
< p >
4. Set wireless parameters
Set the corresponding wireless name and wireless password on the wireless network. Wireless name It is recommended to use numbers or letter combinations, do not use Chinese, wireless password You are advised to set a combination of 8 to 63 digits and letters. Yes.
< p >
After the setup is complete, the router will send out a 2.4G wireless signal at the same time.
If you use a dual-band wireless router, you need to set the 2.4G and 5G wireless name and wireless password respectively.
,
At this point, the router is set up. After connecting the computer to the router, you can directly open the Web page to the Internet, without using the computer. Broadband connection " It's time to dial.
If you have other computers that need to be connected to the Internet, connect the computer directly to any free LAN port on the router with a network cable. If it is a wireless terminal such as a laptop or mobile phone, you can connect the wireless signal of the router to the Internet and do not need to configure the router.
,