Xiaomi air purifier cleaning steps are as follows: 1. Open the rear filter element cabin door of Xiaomi air purifier, unlock and remove the filter element.
< br >
2, millet air purifier outlet and impeller are removable design to facilitate the user to clean work. Gently press with both hands and rotate counterclockwise at an Angle of about 20 degrees to remove the top outlet hood of the Mi air purifier.
3. One hand blocks the impeller from rotating, the other hand rotates the impeller fastening device clockwise, holds the center of the impeller and lifts it vertically to remove the impeller, and you can see that there are also a lot of dirty accumulation in the air outlet area.
4. Use a vacuum cleaner to clean the dust accumulated at the honeycomb port of the lower fuselage. Then clean the residual dust in the filter chamber.
5, waste toothbrush do not throw, cleaning work many times sent on the big use. Use a brush or toothbrush to remove the garbage in some small corners of the upper part of the Xiaomi air purifier.
6. Heart suction removes dust and dirt inside the air outlet to prevent falling to the air engine room. The corners are difficult to clean and continue to brush while sucking.
7, if conditions permit, such a dirty air purifier filter can be replaced in advance even if it does not reach the use period. If you do not replace it temporarily, you can use a vacuum cleaner to remove the primary filter waste.
8, the air outlet net cover and impeller can be washed, adding an appropriate amount of detergent soaked easier to clean, clean water after drying.
9. Finally, use a wet rag to wipe the machine in all directions. If the machine looks yellow, you can spray an appropriate amount of neutral detergent to wipe it.
10. Install the impeller, air hood and filter element according to the opposite steps removed before, and close the hatch door. Boot test, if the filter element is replaced, it is necessary to reset the filter element.