The debugging of the dispensing machine is mainly carried out according to the specific operating steps. Here are the general steps for debugging automatic and manual functions:
Debugging automatic functions:
1. Connect the power supply and turn on the power switch of the device.
2. Set the automatic mode of the dispensing machine according to the instructions of the equipment manual.
3. Ensure that all parts of the machine are properly installed and connected, and are not loose or damaged.
4. Check the glue supply system to ensure that the glue supply is sufficient and the glue pipes are not blocked. 5. Set the operating parameters of the dispensing machine, such as speed, pressure, glue amount, etc. 6. Place the workpiece that needs to be dispensed on the working platform and fix it as required.
7. Press the start button or trigger signal to trigger automatic dispensing.
8. Observe the dispensing quality and adjust the parameters until the requirements are met.
Manual debugging function:
1. Connect the power supply and turn on the power switch.
2. Set the manual mode of the dispensing machine according to the instructions of the equipment manual.
3. Ensure that all parts of the machine are properly installed and connected, and are not loose or damaged.
4. Check the glue supply system to ensure that the glue supply is sufficient and the glue pipes are not blocked. 5. Place the workpiece that needs to be dispensed on the working platform and fix it as required.
6. Manually control the operation of the dispensing machine, press the glue button or pedal to start the dispensing.
7. Observe the dispensing quality and adjust the parameters as required until the requirements are met.
During debugging, pay attention to safety operations and follow the instructions in the device manual. The specific commissioning steps may vary according to the brand and model of the dispensing machine. It is recommended to refer to the equipment manual or consult the technical support of the manufacturer before commissioning.
Adjust the pilot glue machine, you need to set the parameters of the machine, including dispensing speed, dispensing pressure, dispensing time, etc. Then choose automatic or manual mode as needed.
In automatic mode, the machine will automatically perform the dispensing operation according to the preset parameters, while in manual mode, the machine needs to be manually controlled for dispensing.
When debugging, you can first select the manual mode for testing to determine whether the performance and parameters of the machine meet the requirements, and then switch to the automatic mode for actual operation.
After the debugging is completed, it is also necessary to carry out certain checks and tests to ensure the stability and performance of the machine.