1、启动\/停止
Start\/stop measurement
2、电源\/数据
Connect to the power supply for SPC output\/data saving\/printout
3、cal \/ std \/ range
Calibration\/roughness specification\/conversion measurement range setting mode
4、cutoff \/切断
Convert intercept cursor key (top)
5、毫米\/英寸\/英寸
mm\/inch Public\/Imperial conversion cursor key (bottom)
6, LCD screen
7、参数
Convert the resulting roughness parameters to display
8、n\/ENT
Conversion interval number. Confirm key (when setting conditions)
9、曲线\/过滤器\/工具\/过滤器
Convert the measurement curve\/filter\/determine whether it is qualified\/Customize the setting mode
10、mode \/ esc
Switch to another condition setting mode
ESC (Escape)
Switch to remote mode
Cursor key (left)
Turn off the power