The repair procedure is as follows:
< br >
1. Check whether the computer can use the mouse normally. First, confirm that the computer can use the mouse normally. If you can't confirm it, you can find a wired mouse to test it.
< br >
If you can not use, it is necessary to solve the problem that the computer can use the mouse first; If it works, plug the wireless mouse receiver into the USB port on your computer.
< br >
2. Check whether the mouse battery is installed correctly Check whether the wireless mouse battery is installed correctly, some brands of new mouse battery is installed, there is a small insulating paper strip, open.
< br >
3. Check whether the wireless mouse switch is turned ON. Check whether the wireless mouse switch is set to the ON position. Some entry-level mice have no switch, which is installed with a battery to indicate that it has been turned on.
< br >
4. Check that there is no object blocking between the receiver and the mouse to ensure that there is no obvious object blocking between the receiver and the wireless mouse, some USB interfaces are in the groove surrounded by metal plates, so that the signal will be seriously shielded, it is recommended to use an extension cable or replace other locations of the USB interface. If it is a desktop computer, you are advised to install the USB port on the front of the chassis. Ensure that there is no WIFI wireless signal source or other high frequency wireless signal source within 2 meters.
< br >
5. Replace different USB ports for testing of computers with different interfaces; Replace the computer test; Battery replacement test. Some newly bought mice will also have the original battery failure.
1. First of all, the first case may be electromagnetic interference, at this time we can prepare a usb extension cable, the wireless mouse receiver connected to avoid the receiver directly connected to the computer, reduce electromagnetic interference.
< br >
2. If this still does not work, we can try to turn off the switch of the wireless mouse, which needs to be kept realistic for at least 1 minute after closing, and then it is OK to turn on again.
< br >
3. If it still does not work, it is likely that the battery of the wireless mouse is out of power, resulting in a less sensitive mouse response, we can try to change a battery, should be able to solve the problem.
< br >
4, if the battery can not be changed, it may be the computer Settings out of the problem, you can enter the \"control panel\
First, check whether the mouse switch button is open normally.
Second, check whether the battery has power, whether there is insufficient battery power, you can button down the mouse battery and replace the new battery.
Third, check whether the receiver is normally installed, you can re-plug the receiver or change the usb interface to try, if not, it means that the receiver is broken, you can change a receiver.
Fourth, whether to exceed the effective distance, the effective distance of the wireless mouse is not the same, if the wireless mouse is too far away from the computer, it will cause no reaction, it is recommended to reduce the distance to try.
Fifth, if the above methods do not work, should consider whether the internal components of the mouse is damaged, can be re-purchased or repaired.