1, charging the vacuum cleaner has been showing the charging state charged overnight is not full of the reasons are as follows: The vacuum cleaner is not connected when connecting the charger Handheld cordless vacuum cleaner is not charged , resulting in leakage is not full Handheld cordless vacuum cleaner is not charged , reconnect the vacuum cleaner and charger. Vacuum cleaner for a long time noWith the handheld wireless vacuum cleaner does not charge into the electricity , resulting in the battery is too low automatic protection, it does not charge into the electricity, after the main power is turned off, plug the charger into the machine, rush for more than half an hour to see if it can be full.
2. Disconnect the power supply and reinsert the charging port. The controller that controls the indicator light is damaged, or it is faulty, which will cause the blue light to be on all the time. You can disconnect the power first, and then replace the controller inside with a new one, and then plug it back in. In the process of use, if the electricity has not been full, or is chargedIf the electrical port is loose, the indicator light will be on all the time, and you can reinsert the charging port.
3. The battery line is damaged and disconnected. According to the inquiry on the Philips official website, the Philips vacuum cleaner shows that it has been charging due to the circuit break and short circuit, and it is recommended to check the integrity of the battery line. Philips is a Dutch company that produces lighting, home appliances, medical systems and other products. The company has production bases in 28 countries around the world and owns 80,000 patents.
4, Handheld cordless vacuum cleaner can not be charged 2, please check whether the back center of the phone is placed in the center of the wireless charging board. When there are inclusions between the mobile phone and the wireless charging pad, it may not be able to charge normally. Please check the back of the phone. If the protective phone cover used is too thick may hinder wireless charging, it is recommended to remove the phone cover and try to recharge. Please use the original charger. If you use a non-original charger, you may not be able to charge normally. 3, motor damage. Only replace the new motor, if the motor bearing is damagedOr carbon brush wear, can be replaced with a new bearing or carbon brush. 4, first test whether the charger output voltage is normal. Then do the replacement process. 1, the vacuum cleaner battery aging, so that the battery will not be charged into the electricity, of course, the red light will always be on, if this is really the case, the user is best to send the vacuum cleaner to the repair shop to overhaul, or directly replace a new battery. The red light here isn't a battery indicator, it's a dusty fingerThe indicator light, the dust cup of the vacuum cleaner is filled with garbage, and if it is too dirty, the red light will be on all the time. 2, please check whether the back center of the phone is placed in the center of the wireless charging board. When there are inclusions between the mobile phone and the wireless charging pad, it may not be able to charge normally. Please check the back of the phone. If the protective phone cover used is too thick may hinder wireless charging, it is recommended to remove the phone cover and try to recharge. Please use the original charger. If you use a non-original charger, you may not be able to charge normally. 3, Why can't the vacuum cleaner charge? There are many types of vacuum cleaners that can't be chargedThe reason why. First, there may be a fault in the charger itself, such as a damaged power cord or a short circuit in the charging head. Second, it may be that the battery inside the vacuum cleaner is damaged or aged and cannot receive electricity to charge. Finally, it is also possible that the charging interface or connection cable of the vacuum cleaner is loose or damaged, resulting in normal contact with the power supply for charging. 4, the power failure is one of the common problems that lead to the vacuum cleaner not being charged. First, check whether the socket is working properly, try to connect other appliances to the same socket, and confirm that the power supply is normal. If there is no problem with the socket, check the vacuum cleaner power cord for damage or poor contact.Sometimes, the power cord may be worn or broken due to prolonged use, resulting in abnormal charging. At this point, you need to replace the power cable and try charging again. 1, the battery of the vacuum cleaner is aging Handheld cordless vacuum cleaner can not be charged , so that the battery will not be charged Handheld cordless vacuum cleaner can not be charged , the red light showing the power will of course be always onIf this is really the case, the user is best to take the vacuum cleaner to the repair shop to repair it, or directly replace a new battery. The red light here is not the electricity indicator, but the dust full indicator, the dust cup of the vacuum cleaner is filled with garbage, too dirty, of course, the red light will be on. 2, in addition, it is likely that the battery of the vacuum cleaner is aging, so that the battery will not be charged, and the red light will always be on. Usually do not pay attention to power off, or a long period of intermittent charging will lead to the aging of the battery, just like the mobile phone battery. 3, noThe power supply might be bad. It should be the battery of the vacuum cleaner aging, so that the battery will not be charged, the red light showing the power is on, if this is really the case, it is best to take the vacuum cleaner to the repair shop to repair it. 4, the charger is faulty, the charger may fail to charge the vacuum cleaner, resulting in no charging. The battery is faulty. The vacuum cleaner battery may be damaged or invalid and cannot be charged, resulting in no charging. The charging port of the vacuum cleaner is faulty. The charging port of the vacuum cleaner may be damaged or loose, and the charger cannot be reached. 5, electricityThe pool is bad, the battery is bad, the charging does not enter, the charging current is small, and the green light is naturally on. 1, that is, the charger is faulty, there are many reasons for the charger failure, but the common is that the capacity of the filter capacitor decreases or fails, many times, it can not be measured, the filter capacitor is changed! Then there is a problem with the output current sampling resistance, which is generally about 0.1Ω, 2W, when the resistance is replaced, the resistance value cannot be changed, and the power is betterAs long as it can fit. 2, if the battery of the vacuum cleaner is put for a long time, it will be damaged, if this is not the case, check what the charger shows, if the charger starts to show the green light, it is because it is not plugged in or the connection is broken. 3, the charger output line is broken or not in contact with the socket, and then the battery (electronic) is not good. Judge whether the battery is good or bad: if the lamp is red when the charger is plugged in, the light is green soon, indicating that the battery is not good, if the green light is plugged in the charging plug, one is the line problem. 4, can only be checked step by step, first check the power supplyThe wire plug and all the wires are damaged and burned traces, if the power cord is randomly inserted and removed to see if there is no abnormality inside the socket, and then carefully touch and listen to the charging there is no movement and temperature, if there is no problem, you have to consider the internal battery and other reasons. 5, cordless vacuum cleaner flashing green under normal circumstances because the battery needs to be charged, or the battery internal damage caused by factors such as. If the flashing green light is intermittent, check to see if the vacuum cleaner's cleaning filter needs to be replaced or cleaned, or if the vacuum cleaner's pipe is blocked. 6, Dyson vacuum cleaner chargingThe indicator light is off after 3 seconds and cannot be charged, which is caused by the damage of the Dyson vacuum cleaner battery. The Dyson vacuum cleaner charger automatically recognizes that the battery has been damaged, so it will automatically cut off the internal power supply, and will not charge the damaged battery. In this case, the vacuum cleaner battery can be replaced first, and then it can be charged normally. The specific steps are as follows: Prepare the Dyson vacuum cleaner. 1, the power failure is resulting in the vacuum cleaner can not be chargedOne of the common problems. First, check whether the socket is working properly, try to connect other appliances to the same socket, and confirm that the power supply is normal. If there is no problem with the socket, check the vacuum cleaner power cord for damage or poor contact. Sometimes, the power cord may be worn or broken due to prolonged use, resulting in abnormal charging. At this point, you need to replace the power cable and try charging again. 2, the battery of the vacuum cleaner is aging, so that the battery will not be charged into the electricity, of course, the red light will always be on, if this is really the case, the user is best to send the vacuum cleaner to the repair shop to repair it, orJust replace the battery with a new one. The red light here is not the electricity indicator, but the dust full indicator, the dust cup of the vacuum cleaner is filled with garbage, too dirty, of course, the red light will be on. 3, in addition, it is likely that the battery of the vacuum cleaner is aging, so that the battery will not be charged, and the red light will always be on. Usually do not pay attention to power off, or a long period of intermittent charging will lead to the aging of the battery, just like the mobile phone battery. 4, may be the battery is bad, so can not rush into the electricity. So this is the time to replace the original battery. Because of electricityPools have a lifespan, usually 2-5 years. Specific with the use of the environment has a direct relationship. There are various causes of failure, and it is necessary to check, test and judge gradually from outside to inside, from mechanical to electrical, from software to hardware. 5, Dyson vacuum cleaner charger indicator light 3 seconds after off and can not be charged, such a situation, because the Dyson vacuum cleaner battery damage caused. The Dyson vacuum cleaner charger automatically recognizes that the battery has been damaged, so it will automatically cut off the internal power supply, and will not charge the damaged battery. In this case, the vacuum cleaner battery can be replaced first, and then it can be charged normallyThe specific steps are as follows: Prepare the Dyson vacuum cleaner. 6, check whether the charger is faulty, open the robot switch to check whether the robot can operate normally. If after turning on the power supply, long press the switch, let go and start sweeping, it indicates that the charger is faulty. The vacuum sweeping robot is faulty, and it needs to be contacted for repair. Detailed steps: check whether the charger is in poor contact, shake left and right to check whether there is a break. Find the side of the robot, power switch, turn the robot on. Why won't the cordless vacuum cleaner charge?
Why does the vacuum cleaner stay on when it can't be charged?
What happened when the vacuum cleaner failed to charge, the battery plugged in is green
The vacuum cleaner has not been charged what happened