1, is the line of the problem can be replaced Millet 9 wireless shutdown to charge . If it is the interface problem Mi 9 wireless shutdown abilityCharge , use a sharp knife to gently press the interface inward. It can usually be solved. If you replace the charging head and line after Mi 9 wireless shutdown to charge , or obviously slow charging speed, easy to heat, it is best to replace the interface after the fault. Troubleshoot system faults. Back up data and contacts.
2, no. Maybe there's something wrong with your Xiaomi phone system. It could be a software problem. The ability to charge after restarting is often due to the system's stutter, which causes the system to have no reaction when the tail plug is inserted into the data line. This canCan be due to the fact that you often do not restart the mobile phone resulting in the mobile phone stuck, for the mobile phone data line access due to the reason of the system did not make the first response, so it needs to restart after the good.
3, millet shutdown to charge the reason and solution: check whether the data cable is firmly inserted. Try to plug the data cable firmly, the newly bought will be a little tighter, the plug as deep as possible. It could be a system card. Rebooting the phone will fix it. The phone hardware is faulty. At this time, only the mobile phone can be repaired at the maintenance place.
4, millet phone boot charge does not go into the electricity, shut downTo keep the battery healthy.
Reasons and solutions for millet shutdown to charge: Check whether the data cable is firmly inserted. Try to plug the data cable firmly, the newly bought will be a little tighter, the plug as deep as possible. It could be a system card. Rebooting the phone will fix it. The phone hardware is faulty. At this time, only the mobile phone can be repaired at the maintenance place.
These problems may cause an exception during charging, and the phone needs to be restarted to charge normally. It is recommended to replace the normal charger to solve the problem. Battery problems Aging or damaged batteries can also cause problems when charging.In this case, it is recommended to replace the battery to solve the problem. The problem that Xiaomi's phone has to be restarted each time it is charged could be caused by a software issue, a charger issue, or a battery issue.
Check whether the data cable is firmly plugged in. Try to plug the data cable firmly, the newly bought will be a little tighter, the plug as deep as possible. It could be a system card. Rebooting the phone will fix it. Three clear data. Enter Recovery. Method to enter Recovery: In the shutdown state, press and hold down the Volume Increase button and then the Shutdown button. When the startup screen appears, release the button and enter Recovery.
The phone can not be charged when the phone is on and the phone can be charged when it is off. This is because the battery has current in the outflow of the phone when the phone is on, the charger is plugged in to recharge the battery at the same time, the battery is also providing the phone to boot Mi 9 wireless shutdown to charge working current, that is, the battery has current in the outflow, At this time, although the charger is charging the battery, it cannot make ends meet.
To protect smallMi 9 wireless shutdown can charge We Mi 9 wireless shutdown can charge mobile phones and batteries, shutdown charging is a good habit. This article will delve into the reasons and benefits of charging off to help readers better understand the topic. The current is unstable when you turn on the current is unstable, maybe the phone or the battery has the risk of burning, but also may produce electromagnetic radiation. Therefore, in order to protect our cell phones and batteries, it is a good habit to shut down and charge them.
Please confirm whether the phone has not been used for a long time or has not been reached after shutting down with low powerIt is recommended that you connect the charger and charge it for more than 30 minutes to see if the phone responds.
When the phone is turned off, the identification circuit does not work, and the power only constitutes a charging loop through the USB connection, so it can be successfully charged; When the phone is turned on, due to the fault of the mobile phone identification circuit, it cannot identify whether the data line is in the charging state or in the data transfer state, so the charging fails; When it is in the charging state and then turned on, the phone can be successfully charged because the fault of the identification circuit has been set to the charging state.
If viv is usedo Mobile phone, it is recommended to carry mobile phone, charger, data cable, go to the service center processing, enter the browser to search vivo official website -- service -- service center -- view all -- Select provinces and cities to query the local service center address and contact information.
If you use vivo mobile phone, you can charge it on and off.
2, red rice mobile phone boot charge does not go into the power off can be charged as follows. You can open the back cover of the phone and visually check whether the USB management chip on the motherboard is obviously damaged. If there is no obvious damage, then measure the chip each pin to the ground voltage data is normal. If there is an anomaly, check the components around the chip and replace them if necessary.
3. It is possible that the system is incompatible. Maybe the phone died. Or maybe the system crashed. The charging environment is affected by other magnetic fields. There's something wrong with the battery.The system version is too early. Procedure The solution is as follows: change the charging environment, such as change to a different place to charge or change to the computer usb charging try. If possible, please replace a cable or charger for charging.
The following are possible causes and solutions: Please confirm whether to use the standard charger and charging cable to chargeIt is recommended that you use the standard charger and charging cable for charging. Please confirm whether the phone has not been used for a long time, or if the phone has not been charged in time after the low power shutdown, the battery may be over-discharged. It is recommended that you connect the charger and charge it for more than 30 minutes to see whether the phone responds.
If you use vivo mobile phone, it is recommended to carry mobile phone, charger, data cable, go to the service center for processing, enter the browser to search vivo official website -- service -- service center -- view all -- Select provinces and cities to query the local service center address and contact information.
Poor contact: checkRepair method: If the phone's interface and charging wire are not connected well, the phone may not be imported to charge, check it. First check whether the phone is blocked by foreign objects in the bottom port. Computer charging: If the above method is not possible, you can connect the phone with the data cable and the computer to see if it can be charged, if you can be sure that the phone charger has a problem.
Can be replaced with a charging head. Or take a thin Mi 9 wireless shutdown can be charged The metallographic sandpaper cut the appropriate size Mi 9 wireless shutdown can be charged , fold in half a few times, gently polish a few times at the interface, and then plug in and charge. In addition, we should also pay attention to try not to play with the mobile phone when charging Mi 9 wireless shutdown to charge , so that the life of the mobile phone battery will have a better guarantee.
Method Click the system update icon -- Menu -- Restart to Recovery mode (recommendedLong press the power button under Volume to enter the second method will appear, select Recovery Mode (Volume down = select, volume up = Confirm in all the following operations) After the completion of the above operations, an Android robot will be displayed on the interface, press the power button to enter the Recovery operation interface.
Maintenance method Mi 9 wireless shutdown can be charged : Replace the power cord or data cable Mi 9 wireless shutdown can be charged : shutdown and restart: overhaulMethod: Other problems are tested or can not solve the phone off to look at it, may be a common problem of smart phones. Temperature reasons: Maintenance method: The battery is particularly sensitive to temperature, if the user's phone feels particularly hot, put it aside to see if it can be charged.
The charger or data cable is faulty. Replace the charger and data cable that can be charged normally to see if it can be charged. If they can be charged, it is the charger or data cable is broken, replace a new set of charger data cable. The charging port of the mobile phone is faulty. Check whether there are foreign objects blocked in the bottom port of the phone, resulting in aThe data cable contact is not good, if you find a foreign body blocked with small tweezers can be removed. There's something wrong with the cell phone system.