The method of making a wireless charger is as follows: Attach the module to the place where the MicroUSB interface is compared. Connect the MicroUSB or Lightning port on the module to your phone. If there is double-sided tape on the receiver, you can glue it directly to the back of the phone. If it doesn't come with it, you have to figure it out yourself. Choose the most suitable position, be careful not to let the part of the connection line have the phenomenon of warping.
Soldering iron, copper wire, resistor, transistor, capacitor.That will do. So wireless charging is simple. But I suggest you don't do it yourself. It's all special materials. If you do it for fun, just make an oscillating circuit.
The sending coil connects to the wired power supply to generate an electromagnetic signal, and the receiving coil senses the electromagnetic signal at the sending end to generate a current to charge the battery. Prepare materials and tools: Wireless Charger kit: charger, charging base, charging cable, transmitter and receiver. iPhone6 Wireless Charging kit: reed tube, wired tail plug, iPhone6 back cover, iPhone6 back cover glass. Very simple installation
1, you can buy a wireless charging receiver, paste it on the back of the phone or insert the phone charging port, the advantage of this method is that the cost is low, there is no need to replace the phone or disassemble the phone inside, the disadvantage is that it may affect the beauty and feel of the phone, as well as increase the wear and tear of the charging port.
2, to change the ordinary mobile phone to wireless charging, usually need to use a wireless charging receiver and corresponding modification tools. Please note, however, that this modification may damage the phone or void the warranty, so it is recommended to proceed only after fully understanding the risks and consequences. Wireless charging technology has grown in recent yearsPopular, it allows users to charge devices without having to plug in a cable. However, not all phones support wireless charging natively.
3. Open the Settings of the Huawei mobile phone. Click the "Battery" option to enter. On the battery page, click the "Charging Settings" option to enter. On the Charging Settings page, turn on Wireless Reverse Charging. Finally, wireless charging can be successfully connected.
1, the second flightDegree at a glance to know that there is something, because Chen Weiguang in this fit modification on the front and back to spend Fit wireless charge modification more than a hundred thousand, each change can be said to be a good thing, ENDLESS brakes, BBS brakes, RECARO seats, KW shock, MUGEN steering wheel and so on, Even the audio also changed Fit wireless charge modification more than 40,000 yuan.
2, at the same time, the third-generation fit Fit wireless charging modification is also a variety of gameplayThere are basic stretch, film, but also depth to change the engine, change the kit and so on. So until now, when you see the third-generation Fit on the road, there are at least eight out of ten, more or less there will be some modifications. In other words, this is a strong verification that the fit circulated online in recent years is not better than pushing into the sea.
3, easy car original "buy fit does not change, it is better to push into the sea", in the hearts of car friends, Fit has always been a classic and highly topical model, and GK5 in Honda fans is to create a "Honda super run" myth. Rich retrofit parts and deep retrofit potential, let everyoneMore play car enthusiasts flock to, and even gave birth to the "civilian super run" such a nickname.