1, Method 1: This is the simplest one, directly apply a wet towel to the glue spot, after a period of time 02 will become soft, and then wash off Method 2: In the place with 502 glue stains use the same 502 to melt, softRemove.
2, use banana water droplets on the glue stains, at the same time with an old toothbrush constantly stir brush, until the glue stains become soft off, and then rinse with clean water, repeatedly scrub, brush until clean.
3, you can use a wet hot towel to stick 502 there. After ten minutes of curing 502 will become soft and can be removed. You can also drop a drop of 502 on the place where there is 502, and the cured 502 will become soft, so that a towel can also be removed by dropping 502 on the original place to melt the original 502, and then quickly wash it off with water.
4. First, use banana water drops at 502 Glue stains, and then brush constantly against the glue stains, after a period of time, the glue will become soft and fall off, then rinse with water, and then dry. The second, the use of insulating oil, but it is difficult to find insulating oil, generally in the transformer, insulating oil effect is very good, 502 glue can quickly become soft, and then directly washed off.
Dissolve in organic solvent. Common organic solvents are: gasoline, banana water, benzene, toluene, alcohol, coalOil, chloroform, etc. It is recommended to try using gasoline or banana water first, if not, you will go to the chemical store to buy benzene or toluene, and use it in a place with good ventilation effect. Remove the lock and soak it in solvent for about 2 hours.
First, use banana water droplets on 502 glue stains, and then use the brush to brush the glue stains constantly, after a period of time, the glue will become soft and fall off, then rinse with water, and then dry. The second, the use of insulating oil, but it is difficult to find insulating oil, generally in the transformer, the insulating oil effect is very good, 502 glue can quickly soften, and then directlyBy sticking the protective cover with glue, the voltage will be unstable when charging in the future, and it will cause short circuit and cause accidents. It is best to replace the new charging port, or go to a professional repair shop for repair.
Wireless charging assembly glue Do you apply it to the metal piece of the plug? The plug is powered on mainly by the metal piece of the plug, if wireless charging glue you glue coated on the metal piece may lead to poor contact, electrical equipment without power. It is recommended to clean the glue before use. Pay attention to the safety of electricity.
It is fixed on the wall by the card slot, it is not recommended that you use 502 glue. Because 502 can be corroded, the high heat temperature will melt the socket and cause use, and more serious may burn the line inside. It is recommended that you press the socket directly into the wall, it can be stable and firm. Convenient and practical, but also relatively safe to eat, will not affect the use.
No, don't use glue to stick more than the glue can bear. Even if it works for a while, it's like a ticking time bomb.