Can drop some lubricating oil. There are three ways to maintain hair clippers:
1, the maintenance of the knife head: the hair clippers used by the family are basically waterproof. After the hair, remove the knife head, with the small brush attached to the direction of the blade to clean the crumbs, and then clean the knife head with water, and be sure to dry after cleaning to prevent rust. After the blade is completely dry, add a few drops of lubricating oil to the blade. If the tool head is replaceable, the tool head should be replaced regularly.
2, fuselage maintenance: use a small brush to clean the broken hair on the motor head of the fuselage, be sure not to flush the motor head with water to prevent water into the fuselage. Do not clean the fuselage with acidic substances, it is best to wipe the fuselage with neutral lotion.
3, battery maintenance: In order to maintain the service life of the battery, it is best to be fully charged and put it away again after use, under normal use, it is also necessary to discharge the electricity clean and re-charge it at intervals, if it is not needed for a long time, it is necessary to charge it at intervals.
< br >
There are two possibilities, one is that the clamping bolt is not tightened, the other is that the tooth surface used to cut the hair is too blunt to effectively cut the hair.
< br >
Both of these conditions will cause the hair to enter the joint surface of the moving and fixing pieces, and pinch the hair.
< br >
The first case is easier to understand and can be solved by tightening the fastening bolt.
< br >
In the second case, the hair goes into the teeth, and there are only two possibilities, either to cut it or to keep cutting it. Cutting constantly, the hair will not retreat beyond the teeth, it will force the metal sheet deformation, widening the gap, at which time the hair is squeezed into the stationary piece. The only solution is to take it to a sharpener and sharpen it again.
If it does not take long to buy it should be a voltage problem, in the purchase of electric clippers generally have to send the key, on the edge of the electric clippers, there is an adjustment knob, there is a little fine tuning, there is noise is adjusted on the other side... If the time is long, it is time to change the blade.
In fact, most of the cases of hair clippers clamping hair are because of the material of the blade, the power size, and whether the blade is aging. If it is such a problem, you can apply lubricating oil or replace the tool head appropriately. If it is because the hair is thick and dense, choose the right power and do not cut too fast. baby care does not hold hair, and the level of appearance is very high.
An electric hair clipper is a method of using an electric hair clipper instead of manually combing your hair, designed to make it faster and easier to arrange your hair. When clipping hair, the hair is clipped in the clip of the electric fader, and then through the heating and vibration of the electric fader, the hair is more smooth and neat. However, the use of electric hair clips requires attention to temperature and time, so as not to cause damage to the hair. At the same time, frequent use of electric hair clips may also lead to dry, brittle hair, so it is recommended to use moderate amounts, or combined with other methods of hair protection.
The first is that there is no oil, and there is a feeling of frustration when the knife head is rubbed back and forth, so it is easy to clip the hair.
< br >
The second reason is because the blade is not fast. You can unscrew the tip and buy a new one.